Presenting in NZ the all-new BOZ Starter Kit from ELATE Vape. the BOZ highlights a 650mAh Battery and is charged by means of small scale USB. The BOZ creates clean taste without dry hits, with both low voltage and high voltage batteries. The base sort natural cotton loop of pursue tank can deliver incredible measure of vapors.
Elate Boz/ Chase tank Coils
- Material: Aluminum+Pyrex Glass + Green Plastic
- Output Voltage: 3.7V
- The maximum Current: <30A
- Battery Voltage Range: 3.2-4.0V
- Battery Capacity: 650mAh
- Atomizer Ohm Range: 1.5ohm
- Premium protection circuit installed
- Turn ON/OFF the device at will save battery.
- Volume of automizer 1.9ml
- Top filling tank
What's in the Kit:
- 1x BOZ battery
- 1X chase Atomizer
- 1X Chase Coil 1.5ohm
- 1x USA Cable
- 1X User Manual
How to use:
Before you start smoking, properly prepare your e-cigarette. Do it in a few simple steps:
- Step 1 - Fold the parts: Frist, put all part together. After connecting the battery and the atomizer, the electronic cigarette will be ready for filling liquid. Your e-cigarette is currently blocked, so it does not discharge.
- Step 2 – Fill the atomizer with liquid: When doing this, remember three basic principle.
- Prepare for use: Unscrew the bottom of the atomizer with the heating unit form the atomizer barrel. Apply a small amount. Liquid for holes saturating the heater (3 drops per hole). Turn the base of atomizer with the sleeve.
- Filling in the package: Unscrew the bottom element of the body, gently tilt the tank, and remember to pour the liquid on the walls to the level of inner sleeve of the sleeve. After the first filling of the atomizer with liquid, wait for 15 minutes to heat up the heater absorbed liquid accordingly. In order for the liquid to spread evenly and soak the heater, roll the atomizer intensively in your hand.
- Step 3 – Click 5 times: To turn the battery on or off, press the button 5 times at high speed. If the LED above the button flickered several times, the battery is ready for use or has been turned off. If not, try again.
- Step 4 – Start e-smoking: Your e-cigarette is now ready for use. In case of a dedicated method of puffing directly into the lung (DL) we recommend making long and deep breaths. In case of dedicated mouth-lung (MTL) method, we recommend making short puffs.
- After the few days, the liquid in the container may become darker. It is enough to unscrew the upper element of the body, pour out the remains and set the atomizers for several hours in an upright position – s that you can drain off the remaining liquid. You can also rinse it with lukewarm water.
Completion of liquid tank:
- Unscrew the bottom of the tank with the heating unit from the tank barrel.
- Apply a small amount liquid to the holes that soak the heater (3 drops per hole).
- Twist the tank base with the sleeve and unscrew the bottom element of the body.
- Top up the tank with liquid
- Screw the lower element of the body back together and put the tank and the battery together.
- Screw the atomiser to the battery.
Replacement of a heat team:
- Turn the tank upside down:
- Unscrew the base
- Unscrew the used heating unit from the base and screw in the new heating unit
- Spin the tank base
Replacement of the sleeve:
- Unscrew the tank base
- Unscrew the upper element of the sleeve body
- Replace the used bushing with a new one
- Screw the item back